Apr 22, 2026

The Complete Vision Inspection Validation Chain In Automated FAT Protocols

Leave a message

 

Article Summary:

Vision systems are the eyes of modern automated assembly lines. This article outlines DROFEN MACHINERY's rigorous approach to validating Keyence vision systems during the Factory Acceptance Test (FAT), from system readiness checks to orientation and zero-position verification, ensuring zero-defect manufacturing for CDMOs.
 
In the automated production of medical devices, 100% In-Process Control (IPC) is the standard. For injection pen assembly lines processing up to 160 units per minute, achieving this level of quality control relies heavily on advanced machine vision. At DROFEN MACHINERY, we integrate industry-leading Keyence vision systems to inspect everything from component color to microscopic alignment.
 
However, a vision system is only as reliable as its validation. During the Factory Acceptance Test (FAT), we execute a complete validation chain to prove that the "eyes" of the machine are sharp, accurate, and fully integrated with the PLC's rejection logic.
 

The Vision Validation Chain

 

Our FAT protocol (specifically within the Operational Tests phase) mandates a multi-step verification process for every vision station on the EcoLine assembly system.
 
1. Vision System Readiness (Test 1.01.03.02)
 

Before any dynamic testing begins, the PLC must confirm that the vision controller is online, the correct inspection program (recipe) is loaded, and the cameras are communicating flawlessly. We simulate a communication loss to verify that the machine will not start or will safely halt if the vision system goes offline, ensuring no uninspected parts pass through.

 

2. Orientation and Feature Inspection (Test 1.01.03.01)
 

Components like the cartridge holder must be inserted in the exact correct orientation. During the FAT, we intentionally feed cartridge holders upside down or misaligned. We verify that the vision system instantly detects the incorrect orientation and triggers the reject mechanism. This test is performed across different product variants (e.g., 60IU and 80IU) to ensure the recipe-driven inspection parameters are accurate.

 

3. Zero-Position Calibration Check (Test 1.01.21.01)
 

High-speed assembly requires perfect synchronization. The "zero position" of critical components (such as the dosing dial) must be exact before the final assembly steps. We utilize vision systems to verify this zero position. During the FAT, we introduce challenge parts where the dial is slightly off-zero. The vision system must detect this rotational deviation and flag the part, proving its capability to perform complex geometric inspections at high speed.

 

Integrating Vision with the Rejection Shift Register

 

Detecting a flaw is useless if the bad part is not securely tracked and rejected. Our FAT validates the integration between the vision system's output and the PLC's shift register. We confirm that when a camera flags a part at Station 3, that specific part is accurately tracked through the subsequent stations and definitively expelled at the designated reject bin, without disrupting the flow of good parts.
 
By rigorously challenging the vision systems during the FAT, DROFEN MACHINERY provides CDMOs with the documented assurance that their turnkey project will deliver flawless injection pens, making their quality assurance processes great again.
 
 

Related Technical Resources

 

 
 
Send Inquiry